Error: Printer halted. kill() called! on homing (Marlin 1.1.9)

#1

Help!

Building my first printer, and every time I try to home any axis (or start a print job for that matter), I get this error when the axis arrives at it’s home position. I have no mechanical endstop, using a MKS GEN1.4 board.

Attached here is my config and my printer settings in Repetier Host. If anyone is able to help I’ll be eternally grateful!

0 Likes

#2
#define USE_XMIN_PLUG
#define USE_YMIN_PLUG
#define USE_ZMIN_PLUG

On the one Hand you are saying you don’t have endstops on the other Hand you are defining endstops in the configuration.h. So how should the Firmware be able to perform a G28?
If you don’t have endstops Marlin won’t know the Position of your printhead after power up. So the only way do set a home without endstops is by manually moving your printhead to your desired home Position and then issue a M92 X0 X0 Z0 command

0 Likes