[WIP][Dolly i3] Cubieboard1/2 Case


Hi, i am currently working on a Case for the Cubieboard (for Octoprint)
It is based on slippyr4 case on thingiverse.


testprint is running and is also a good bridge test XD


It’s funny i am printing with the false settings
(settings for 0.8 nozzle / 0.4 nozzle in)

but it comes out not sooo bad :smiley:


Why are you printing with that orientation? It should lie flat on its back.


This was a test how the Cubieboard fit.
In this orientation i printed only the part which i needed to check that and the print was faster.


That’s not bad at all. Are you working on anything else similar?